Ask Lemmy
A Fediverse community for open-ended, thought provoking questions
Please don't post about US Politics. If you need to do this, try [email protected]
Rules: (interactive)
1) Be nice and; have fun
Doxxing, trolling, sealioning, racism, and toxicity are not welcomed in AskLemmy. Remember what your mother said: if you can't say something nice, don't say anything at all. In addition, the site-wide Lemmy.world terms of service also apply here. Please familiarize yourself with them
2) All posts must end with a '?'
This is sort of like Jeopardy. Please phrase all post titles in the form of a proper question ending with ?
3) No spam
Please do not flood the community with nonsense. Actual suspected spammers will be banned on site. No astroturfing.
4) NSFW is okay, within reason
Just remember to tag posts with either a content warning or a [NSFW] tag. Overtly sexual posts are not allowed, please direct them to either [email protected] or [email protected].
NSFW comments should be restricted to posts tagged [NSFW].
5) This is not a support community.
It is not a place for 'how do I?', type questions.
If you have any questions regarding the site itself or would like to report a community, please direct them to Lemmy.world Support or email [email protected]. For other questions check our partnered communities list, or use the search function.
Reminder: The terms of service apply here too.
Partnered Communities:
Logo design credit goes to: tubbadu
view the rest of the comments
We have a lot of standard sizes that seem to be based on imperial - 12mm (1/2inch), 16mm (5/8inch), 19mm (3/4inch), 32mm (5/4inch) etc.
If you're actually interested in taking a look, here's a link to the dressed timber section of Australia's hardware capital - Bunnings.
I think you just made my point for me. Are those finished milled boards or rough sawn?
In America we refer to rough sawn and finished boards differently; a rough milled board 1 inch thick and 4 inches wide is 4:4x4 "four-quarter by four". This board will be milled to 3/4" by 3 1/2" and called a 1x4 or a "one-by-four." If I tell a sawyer "I'm looking for some six-quarter oak" he knows I'm looking for thicker than usual rough cut stock. "I'm looking for some two-by-sixes" implies I'm looking for pre-milled construction lumber. I can say a lot about the wood I want and the condition I want it in with not many words...to an American sawyer, anyway.
Oh, and then there's board feet! Pre-milled boards bought from retailers like Home Depot or Lowe's are sold price-per-each because retail, but you go to a lumber yard or sawmill you're going to pay by volume in units of "board feet." A board foot is a 12 inch wide, 12 inch long and 1 inch thick board, or 144 cubic inches. Which sounds like a bigger pain in the ass than it is.
That's 'dressed all round' what I'm assuming is finished milled. I'm a very amateur diyer - I'd imagine that if you went to a timber yard here they'd probably have a good idea what you were after. Just read online that most bulk wood is bought by the cubic metre, but all dimensioned wood is by the linear metre.
Yeah, put through the jointer/planer to make the board straight, square and true. Sometimes called "surfaced 4 sides" or S4S.