this post was submitted on 02 Feb 2024
419 points (90.8% liked)

Comic Strips

12491 readers
3394 users here now

Comic Strips is a community for those who love comic stories.

The rules are simple:

Web of links

founded 1 year ago
MODERATORS
top 50 comments
sorted by: hot top controversial new old
[–] [email protected] 47 points 9 months ago (2 children)

That’s why I ignore them all and used the timed dry function. Just make sure to clean the lint trap every single time and you’re good to go.

[–] [email protected] 7 points 9 months ago* (last edited 9 months ago) (1 children)

Last house I rented, when I moved in the dryer lint trap and its housing were so jammed full of lint I could have made a blanket from it. It was astonishing. I don't think the prior tenants knew it needed to be cleaned ever. I honestly wonder how the dryer wasn't broken and no fire had started.

The HVAC filter had a solid inch thick cake of dust and dog fur.

[–] [email protected] 5 points 9 months ago

Our apartment was the same way, had a wonderful little rainbow

[–] [email protected] 5 points 9 months ago* (last edited 9 months ago) (3 children)

I've been living in apartments for the past 18 years and this is the first place I've had that the ~~washer~~ drier has a dampness sensor. It took me about 4-5 loads to discover why it would say that there was an hour left and then turn off like 35 minutes later with some stuff still being damp.

[–] [email protected] 3 points 9 months ago (2 children)
[–] [email protected] 2 points 9 months ago

The sensor sucks. I guess it would only dry the outer layer of clothes and be like "yeah, this is good enough".

load more comments (1 replies)
load more comments (2 replies)
[–] [email protected] 36 points 9 months ago

Rage Against the Washing Machine

[–] [email protected] 28 points 9 months ago (6 children)

For all the folks saying to clean the dryer, clearly you never fucked with the LG dryers. They do this shit straight off bat.

[–] [email protected] 10 points 9 months ago (1 children)

If you don't understand timed drys vs auto drys, which half the settings are, sure, you have problems. Most of the LG settings(I have one of their "smart" dryers and washers) are all auto timed. Placing small loads often won't trip the sensor because there's little moist material to activate it. Running large loads with the filter clogged will end up having it detect more of the dry lint than the wet center of your blanket. Empty the filter and restart it and you'll be amazed to see it'll auto run for another 30 minutes and your clothes come out fine. Or switch to the actually timed dries and it will run the whole time NO MATTER WHAT.

If it's shutting off that fast, it's user error.

[–] [email protected] 5 points 9 months ago (1 children)

There’s also the more dry or less dry options for the sensor-based cycles.

[–] [email protected] 5 points 9 months ago (1 children)

Why is that even a thing? It's a dryer. I want it dry. It's not called a damper.

[–] [email protected] 3 points 9 months ago (2 children)

Why do you hate the planet bro???

[–] [email protected] 7 points 9 months ago

I don't hate the planet. I hate my future grandchildren. I have to make sure they suffer.

[–] [email protected] 3 points 9 months ago (1 children)

ComEd: burns millions of tons of fossil fuels every year to sell us electricity.

BP: woopsies millions of barrels of oil into the Gulf of Mexico.

Every shipping company: burns millions of barrels of bunker fuel transporting shit from one place to another place that could have just made the stuff right there.

Every EcoWarrior on the internet: run your drier until your clothes are only damp, trench crotch is a sacrifice for the planet. Balance the lawn chairs you bought at home depot on your bicycle, man, no one needs a car cause they’re bad for the environment.

I understand you’re joking, but the amount of people who still don’t understand the sheer scale of modern pollution is staggering. What any private individual does, unless they start forest fires as a hobby, is a drop in the bucket compared to what mega corporations do on a daily basis.

[–] [email protected] 4 points 9 months ago (2 children)

I get your point but who do you think those corporations are burning fossil fuels for?

load more comments (2 replies)
[–] [email protected] 9 points 9 months ago* (last edited 9 months ago) (1 children)

Doo

Doo dada doo doo

Doo dada doo dada doo doo

Doo

Doo dada doo doo

Doo dada doo dada dee

[–] [email protected] 4 points 9 months ago

So well written I heard it in my head.

[–] [email protected] 5 points 9 months ago

My LG is a champ and only shuts off early on tiny loads.

[–] [email protected] 4 points 9 months ago (1 children)

Mine works fine, the annoying bit is that every setting defaults to one notch below where I'd consider it acceptably dry

[–] [email protected] 3 points 9 months ago

I have an LG dryer as well and this was the case for me until I realised I could turn off the default "energy saver" mode.

[–] [email protected] 2 points 9 months ago (1 children)

Thank fuck I'm not the only one then, we have had to run ours on high heat all the time, and even twice

load more comments (1 replies)
[–] [email protected] 1 points 9 months ago

The dryer Bob's angry at is a Bosch.

[–] [email protected] 18 points 9 months ago* (last edited 9 months ago) (1 children)

I suspect the manufacturers are gaming the energy efficiency regulations by shutting down early while your cloths are still wet in order to claim that each dryer cycle uses less energy.

Its the low flow toilet debacle all over again. Now you need to run the dryer twice, using even more energy than you would have if it had worked right the first time.

[–] [email protected] 9 points 9 months ago* (last edited 9 months ago) (1 children)

What they specifically do is make the "normal" cycle useless, since the DOE only tests the default cycle setting. Typically the others -- heavy duty, timed dry, etc. -- are as inefficient as they like.

Same deal with clothes washers and dishwashers. Ever look at the energy guide labels on current diahwasher models and notice they're all rated at 270 kWh/yr? That's why. Guess what the minimum to meet Energy Star qualification is.

[–] [email protected] 3 points 9 months ago

This is why the normal cycle on normal dryness is about 3/4th's dry. If you choose the normal cycle with the "very dry" option it works as it should.

No dryer meets the energy star usage requirements under "normal" consumer usage.

It's all a game to meet regulations and marketing.

Just another example of originally well intentioned but deliberately poorly written and implemented laws due to corporate lobbying corrupting them.

[–] [email protected] 17 points 9 months ago (1 children)

My dryer used to do this until I opened it up and cleaned it

load more comments (1 replies)
[–] [email protected] 9 points 9 months ago

I turned off ECO mode to fix that problem.

[–] [email protected] 8 points 9 months ago

Holy shit Bob The Angry Flower!

[–] [email protected] 8 points 9 months ago (1 children)

I think it’s also related to the number of items you put in, and theres a safety setting that doesn’t let it get too hot to prevent fires. I think maybe the cabin gets too hot if there are less items giving off moisture, and so less items will always come out a bit damp.

I had this issue drying underwear, so now I just use an indoor drying rack and air dry. If your heating vents are on the ceiling then you can just place the drying rack under the ceiling vent when you have heat on in the winter :) Air drying is pretty good in the hotter seasons too, might take 24hrs though vs 3-4hrs with heating vent in winter.

[–] [email protected] 2 points 9 months ago

Dryers cycle the heating element. It'll never get too hot as long as the air can flow.

[–] [email protected] 4 points 9 months ago

My dampness sensors went south a long time ago. Cleaned the whole thing out and everything. I'm also at least the second owner. The contacts in the load selection knob also had worn away from use and I had to repair them. I'll be happy to get another three to five years out of it.

I just use the timed dry now and send slightly smaller loads through. It's much more efficient.

[–] [email protected] 2 points 9 months ago

Omg I have this exact dryer and it fucking sucks. It doesn't dry for shit, and all the settings are stupid and useless

[–] [email protected] 2 points 9 months ago

Sometimes the moisture sensor needs to be washed out with cleaning solution/vinegar, or replaced.

Condensation dryers like this one, or heat pump models, don’t cook clothes like standard hot air dryers. They might not feel 100% dry but by the time you fold them they are.

load more comments
view more: next ›