this post was submitted on 11 Jan 2024
975 points (98.5% liked)

Technology

59551 readers
3714 users here now

This is a most excellent place for technology news and articles.


Our Rules


  1. Follow the lemmy.world rules.
  2. Only tech related content.
  3. Be excellent to each another!
  4. Mod approved content bots can post up to 10 articles per day.
  5. Threads asking for personal tech support may be deleted.
  6. Politics threads may be removed.
  7. No memes allowed as posts, OK to post as comments.
  8. Only approved bots from the list below, to ask if your bot can be added please contact us.
  9. Check for duplicates before posting, duplicates may be removed

Approved Bots


founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 4 points 10 months ago (1 children)

Potatoe Potatoh. Point is you size the overall system for quick adjustments, not continuous use. If you can get by with less weight and cost then you do as continuous use does not even begin to appear in the requirements sheet.

[–] [email protected] 0 points 10 months ago (1 children)

How much weight and cost do you think that's going to add?

[–] [email protected] 2 points 10 months ago* (last edited 10 months ago) (2 children)

Do you think that being able to fiddle with your seat position for minutes on end is any way insufficient? Will you ever come close to actually using that feature?

If you answered those with "no", then any extra weight and cost is too much. If you answered with "yes" then get a massage chair and leave the poor car be a car. Feature set follows function.

[–] [email protected] 1 points 10 months ago (1 children)

Adding this functionality will:

Require more IO, add complexity to any wiring harnesses, make repair or replacement more difficult. This all increases cost, probably more than a mass-produced seat motor used by other manufacturers.

For weight and cost, a proper design would have been negligible. Why do you think every other car isn't made this way if it comes down to cost?

[–] [email protected] 1 points 10 months ago

Require more IO, add complexity to any wiring harnesses, make repair or replacement more difficult.

None of those: In modern cars you just plug those things into the CAN bus. One connector.

Why do you think every other car isn’t made this way if it comes down to cost?

Most cars don't have seat adjustment motors. And as to others that have that functionality being able to operate it continuously: [citation needed]. Remember these are off the shelf German car supply parts, you'll find the exact same hardware in, say, a BMW.