curled

Yea you are? Sprinters or Crafters easily fit a stack of sheets, at least in the EU they do

• touch the tip of the solder where the iron meets the pad or the pin

• try to get as much contact with both the pad as the pin as you can

• the pad could be dirty or not hot enough. Especially when the pad is connected to a ground or power plane layer in the PCB it may take longer than expected to reach a sufficient temperature. Usually adding some flux helps remove any dirt.

Did something change? Last time I bought an album on Qobuz i could download the whole thing in a single zip file. This was quite a while ago though

Similar setup here, as a bonus I also connected my jellyfin to Listenbrainz to get recommendations and some sweet stats.