Technology

37604 readers

499 users here now

A nice place to discuss rumors, happenings, innovations, and challenges in the technology sphere. We also welcome discussions on the intersections of technology and society. If it’s technological news or discussion of technology, it probably belongs here.

Remember the overriding ethos on Beehaw: Be(e) Nice. Each user you encounter here is a person, and should be treated with kindness (even if they’re wrong, or use a Linux distro you don’t like). Personal attacks will not be tolerated.

Subcommunities on Beehaw:

This community's icon was made by Aaron Schneider, under the CC-BY-NC-SA 4.0 license.

founded 2 years ago

MODERATORS

[email protected]

Why when a headphoses wire is damaged you dont hear the voice as normal but the backround yes? (lemmy.zip)

submitted 9 months ago by [email protected] to c/[email protected]

7 comments fedilink hide all child comments

So theres Left, Right and Ground wires, there are not "bass" or "hi-freq" wires, so if 1 is damages shoudnt it only hear quieter or not at all?

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 7 points 9 months ago (1 children)

Your question is worded very oddly, but to attempt to answer it, headphones (most) operate off of an analog signal from a DAC (digital to analog converter). In any analog setup you're going to have some amount of signal transmission or line noise unless the two transmission lines are entirely shielded or entirely separated.

[–] [email protected] 3 points 9 months ago

This seems most plausible. OP, if you have a multimeter you could try to trace which TRS terminal has continuity with the damaged wire (if it's exposed) and see which signal it's supposed to carry.