this post was submitted on 12 Sep 2023
132 points (98.5% liked)
Linux
48178 readers
816 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
It's fine if you don't set it up on a dogshit slow rPi and use postgres/redis in the docker compose. Every time I see this comment, it's because of configuration errors or horrible hardware.
Man, use Sharepoint on anything under a dual Xeon and see true lag.
This is true, with a couple gigs of RAM and SATA storage Nextcloud is not at all bad. Assuming an instance with not that much simultaneous users.
It feels like slow sometimes, then after an hour with M365 at work it doesn't feel slow at all.
Is there a way to transition from MariaDB to Postgres? I used the mariadb / redis version of the docker-compose, but now I hear everyone says Postgres is better for performance?
Create your users in the new install, move each users files to the created folders from your old install, and use the OCC addfiles command to enumerate the new files into the new db.
There is a db migration command that I used to do the same thing, was pretty painless, just needed to run that and then update the config iirc
Thanks. Would
occ files:scanwork as well?That's the one. I haven't used it for a while, sounds about right.
I ran it on a Dell EMC server blade and it was still awful. I couldn't help but think I was doing something wrong, because its performance was shockingly bad. I also couldn't get any of the office stuff to work acceptably, so I've given up on it for the time being.