this post was submitted on 26 Nov 2023
56 points (96.7% liked)
Linux
48220 readers
559 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
before you change anything it would be good to use dd and save the whole drive to a bigger drive or maybe compress it with gzip while using dd to save it to a slightly smaller one. That takes a very long time, but gives you the ability to start over with your recovery. Only do that if it's worth to wait several hours.
photorec can also recover some files by looking at the raw data still there, if all else fails.
That’s what people always underestimate about data recovery jobs: you need lots of space. One copy for safekeeping. One to work on. One disk of the same size you store recovered files on.
Whenever friends or family ask me to look at a disk I always tell them to give me the disk and two new ones of the same or greater capacity and I’ll give it a shot. Usually they discover the data isn’t that important after all. If it is I have all I need.
command would be something like this:
dd if=/dev/..../myparition|gzip status=progress > /mnt/external_hd/mypartition.gzip
Wouldn't you want to use
dd if=/dev/sda3 of=/dev/sdc1 status=progress && sync
Where /dev/sda3 is the damaged partition and /dev/sdc1 is the freshly formatted external drive
You'll find your attached devices with lsblk
You're going to want to make sure /dev/sda3(broken partition) is unmounted so as not to write any more data to it.
To add on to this answer (which is correct):
Your "of" can also just be a regular file if that's easier to work with vs needing to create a new partition for the copy.
I'll also say you might want to use the block size parameter "bs=" on "dd" to speed things up, especially if you are using fast storage. Using "dd" with "bs=1G" will speed things up tremendously if you have at least >1GB of RAM.
I totally spaced on BS=4M which I believe is the standard block size for ext4
this clones one parition to another which is fine if you have free partition with enough space lying around. My code was for taking compressed backup of the partition to be restored later if needed. Its less convenient but doesnt require as much space nor does it require an entire partition
Don't you have to read the partition to compress it, which is fine on a healthy partition but can further damage a broken one?
depends on what you mean by "broken". If broken means has bad sector or other hardware issue, then yes OP should transfer data to healthy partition and work from there. though it certainly won't hurt if he attempted to recover data from broken partition (worst the HD dies and OP restore the backup on healthy HD) However he said "i broke my partition" which make me think its software issue, not hardware. in which case, would be faster to recover data directly after taking backup